3670 Main St Mammoth Lakes, CA 93546-9821

permit required if primary use in OMR and MLR districts. (Code 1990, § 17.24.020; Ord. No. 14-02, § 4, 3-19-2014; Ord. No. 15-01, § 4(exh. A, §§ 2, 3), 1-21-2015; Ord. No. 15-02, § 4(exh. A), 3-4-2015; Ord. No. 16-04, § 2a(exh. A), 5-18-2016; Ord. No. 16-09, § 4(exh. 1), 12-21-2016; Ord. No. 18-02, § 5(exh. A, a.), 3-13-2018; Ord. No. 18-05, § 4(exh. A, a.), 11-19-2018; Ord. No. 19-04 , § 4(exh. A, b.), 11-6-2019; Ord. No. 19-06 , § 4(exh. A, b.), 12-18-2019; Ord. No. 20-12 , § 4(exh. B, § a.), 11-18-2020; Ord. No. 2021-03 , § 4(exh. B, § b.), 3-3-2021) 17.24.030. - Commercial district development standards. Subdivisions, new land uses and structures, and alterations to existing land uses and structures, shall be designed, constructed, or established in compliance with the requirements in Tables 17.24.030-1 through 17.24.030-5 in addition to the applicable development standards (e.g., landscaping, parking and loading, etc.) in Chapters 17.36 through 17.56 . However, where accessory dwelling units are a permitted use, the development standards specified in Section 17.52.055 applicable only to accessory dwelling units shall take precedence over the development standards specified below. Additional regulations are denoted in a right column. Section numbers in this column refer to other sections of this chapter, while individual letters refer to Section that directly follow the table. The numbers in each illustration below refer to corresponding regulations in the "#" column in the associated table. Table 17.24.030-1. Commercial Districts-Lot Density and Intensity Standards Development Feature Requirement by Zone Additional Regulations # D OMR MLR Lot Size Lot area 10,000 square feet Lot area, corner lot 11,000 square feet Lot width 75 feet Lot width, corner lot 90 feet Lot depth 100 feet Width for access 50 feet Minimum buildable site area 5,000 square feet Minimum width/depth for a building site 50 feet Maximum slope for a building site 20% Density and Intensity Floor area ratio (FAR) Maximum 2.0, applicable to entire development (A) Table 17.24.030-2. Commercial Districts-Building Placement Standards Development Feature Requirement by Zone Additional Regulations # D OMR MLR Minimum Setbacks (measured from property line unless otherwise stated) Main street and frontage road 0 feet (B) 17.36.090 ; 17.36.100 ;