Nathan Dr Killeen, TX 76541

Large off-premises signs may be permitted in zoning district B-5, and less restrictive subject to the following provisions: a. The distance between the requested large off-premises sign site and the closest off-premises sign shall be greater than one thousand five hundred (1500') feet measured as a radial distance from the sign's base on either side of the street. On S.H. 195 and 201, however, the distance shall be greater than three thousand (3000') feet measured as a radial distance from the sign's base on either side of the street. b. Large off-premises signs shall be set back from the sign's most outer edge a minimum of twenty five (25') feet from the property line or the set back distance required for a building on the selected site, whichever is greater. c. The overall height of a large off-premises sign shall not exceed forty two and one-half (42.5') feet measured from highest point of sign to the grade level of the street closest to the sign and the face shall not exceed six hundred seventy-two (672) square feet with a face height not to exceed twenty five (25') feet and a face length not to exceed sixty (60') feet. d. Unless otherwise restricted, large off-premises signs may only be permitted only on streets classified as principal arterials. (11) Sign operators installing, testing or maintaining off-premises CEVMS shall comply with the following requirements: a. Each message shall be displayed for at least ten (10) seconds. b. A change of message shall be accomplished within two (2) seconds or less, and a change of message must occur simultaneously on the entire sign face. c. Signs must contain a default mechanism that freezes the sign in one position if a malfunction occurs. d. Signs may not display light of such intensity or brilliance to cause glare or otherwise impair the vision of a driver, or results in a nuisance to a driver. e. CEVMS sign light intensity exceeding the following intensity levels (NITS) constitutes "excessive intensity or brilliance:" Intensity Levels (NITS) Color Daytime Nighttime Red only 3,150 1,125 Green only 6,300 2,250 Amber only 4,690 1,675 Full Color 7,000 2,500 f. Prior to issuance of a sign registration, the applicant shall provide written certification from the sign manufacturer that the light intensity has been factory pre-set not to exceed seven thousand (7,000) NITS and that the intensity level is protected from end-user manipulation by password-protected software or other method as deemed appropriate by the building official. g.