Barnhill St Bethel, NC 27812

(5) Rear yard required. Requirements are the same as the current R-6 Residential Zone. (6) Signs. Same as R-15 Residential Zone, which also apply in R-6 Residential Zone. (I) Manufactured home standards. Zoning Code 69 (1) Manufactured homes permitted within the R-6 Residential Zone shall be constructed after July 1, 1976, and meet or exceed the construction standards promulgated by the U.S. Department of Housing and Urban Development that were in effect at the time of construction. (2) Additionally, such manufactured homes shall meet the following requirements. (a) The manufactured home shall be occupied only as a single-family dwelling. (b) The manufactured home shall have a minimum width of 24 feet. (c) The manufactured home shall have a length not exceeding four times its width, with length measured along the longest axis and width measured perpendicular to the longest axis at the narrowest part. (d) The towing apparatus, wheels, axles and transporting lights shall be removed and shall not be included in length and width measurements. (e) The longest axis of the manufactured home shall be oriented parallel or within a ten-degree deflection of being parallel to t he lot frontage, unless other orientation is permitted by the Board of Adjustment following a public hearing. (f) The manufactured home shall be set up in accordance with the standards established by the North Carolina Department of Insurance. In addition , a continuous, permanent masonry foundation or masonry curtain wall constructed in accordance with the standards of the State Building Code, un -pierced, except for required ventilation and access, shall be installed under the perimeter of the manufactured home. (g) The exterior siding shall consist of one or more of the following: 1. Vinyl or aluminum lap siding whose reflectivity does not exceed that of flat white plant; 2. Cedar or other wood siding; 3. Wood grain, weather resistant press board siding; Zoning Code 70 4. Stucco siding; and/or 5. Brick or stone siding; which shall be comparable in composition, appearance and durability to the exterior siding commonly used in standard residential construction. (h) The pitch of the roof shall a minimum vertical rise of three and one -half feet for each 12 feet of horizontal run. (i) The roof shall be finished with a Class A shingles, or better, roofing material that is commonly used in standard residential construction. Corrugated aluminum, corrugated fi berglass or metal roofs shall not be permitted. (j) All roof structures shall provide an eaves projection of no less than six inches.