849 Capri Isle Blvd Venice, FL 34292-2201

PUD (Planned Unit Development) PUD Sec. 2.2.4.4.A. PCD (Planned Commercial Development) PCD Sec. 2.2.4.4.B. PID (Planned Industrial Development) PID Sec. 2.2.4.4.C. CSC (Commercial Shopping Center) CSC Inactive Sec. 2.2.2.5. 2.2.2. Residential Zoning Districts A. Residential, Single-family (RSF-1, 2, 3, 4). 1. Purpose and Intent. The residential, single-family zoning districts (RSF) are intended to establish low to moderate density residential neighborhoods, to implement Strategy LU 1.2.3 of the Comprehensive Plan, and to protect these areas from incompatible uses. The residential, single-family districts offer a range of lot sizes and housing stock (detached and attached) to allow a sustainable mix of single-family residential development. 2. Uses. Uses are defined per Section 2.2.7: Traditional Zoning Districts Use Table. 3. Accessory Uses. Accessory uses are permitted per Section 2.4: Use Definitions and Standards. All accessory uses must comply with the standards of Section 3.1.9: Accessory Uses and Structures. 4. Standards. See Table 2.2.2.A. Table 2.2.2.A. RSF Development Standards Table RSF Development Standards Table RSF-1 RSF-2 RSF-3 RSF-4 Building Height (max) 35' Building Height Exception Standards No Height Exceptions may be granted Building Placement (Setbacks) (min) Front (Street) 20' Side 18' combination of sides 8' 15' combination of sides 6' Rear 10' Waterfront 20' Lot Width (min) 100' 80' 75' 50' Area (min) 15,000 sq. ft. 10,000 sq. ft. 7,500 sq. ft. 5,000 sq. ft. Coverage (max) 35% Density (dwelling units per acre) 2.5 3.5 5.0 5.5 B. Residential, Multifamily (RMF-1, 2, 3, 4). 1. Purpose and Intent. The residential, multifamily zoning districts (RMF) offer a range of lot sizes and housing stock to allow a sustainable mix of multifamily residential development. RMF implements Strategy 1.2.3 of the Comprehensive Plan and allows for Moderate to High Density per the Strategy. 2. Uses. Uses are defined per Section 2.2.7: Traditional Districts Use Table. 3. Accessory Uses. Accessory uses are permitted per Section 2.4: Use Definitions and Standards. All accessory uses must comply with the standards of Section 3.1.9: Accessory Uses and Structures. 4. Standards. See Table 2.2.2.B. Table 2.2.2.B.