409 Brevard St Statesville, NC 28677-4057

R-A, R-20, R-15, R-15M, R-10, R-10M, R-5, R-5M, R-5MF except that entrance signs and subdivision signs may be externally illuminated from dusk until dawn. 3. All temporary signs are prohibited on lots zoned for residential use, except for stake signs as allowed in this section. 4. The following requirements shall be observed in the PUD district, in addition to other standards of this Code and the conditions of PUD district approval: a. A uniform design scheme of signs shall be established for the development as a whole and/or for each building in the development and approved by the Planning Board. b. Plans for the development shall include detailed descriptions of all signs, including, but not limited to, size, height, location, type, colors and materials to be used, lighting and ownership responsibility. c. Plans for signs shall undergo the same review and approval process as is required of other aspects of the development; provided that the City Council may make no modification of these regulations which would permit a sign otherwise prohibited under this Section. d. All signs shall be designed, erected and maintained in accordance with an approved plan. R. Sign Standards for the CB, CBP, Municipal Service and H-115 Districts Prior to any sign clearance being issued in the CB, CBP and Municipal Service Districts by the City, approval shall be obtained by the Downtown Statesville Development Corporation. Signs in the H-115 District require only staff approval. 1. Sign, area. The entire surface of the sign including any masking border, frame, architectural trim or structural embellishment shall be included within the total sign area. The width of the masking border or sign frame structure shall not extend beyond the maximum surface area more than six (6) inches. In the case of signs mounted back-to-back or angled away from each other, the surface area of one (1) side shall be computed. In the case of cylindrical signs, the circumference shall be calculated. Signs in the shape of cubes, or other signs which are substantially three-dimensional with respect of their display surfaces, the display surface or surfaces visible from the street shall be included in computations of area. In case of appurtenances (display portions of signs extending outside the general display area, i.e. pop-ups, cut-outs) shall be computed separately as part of the total surface area of the sign. 2. Signs prohibited in the CB, CBP, Municipal Service and H-115 Districts. The following signs shall be prohibited: a. Signs listed in Section H. b.