3560 Fairview Industrial SE Dr Salem, OR 97302-1154

Industrial and Employment Zone: EC, IC, IBC, and IP Buildings and accessory structures Min. 5 ft. Type A Vehicle use areas Industrial and Employment Zone: IG Buildings and accessory structures Min 10 ft. Type C Vehicle use areas Limitations and Qualifications (1) Zone-to-zone setbacks are not required abutting an alley. (2) Notwithstanding qualification (1) above, zone-to-zone setbacks for buildings and structures are required abutting an alley when the abutting zone across the alley is residential. Vehicle use areas remain under qualification (1), and do not require a zone-to-zone setback abutting an alley when the abutting zone across the alley is residential. (e) Lot coverage; height. Buildings and accessory structures within the ESMU zone shall conform to the lot coverage, height, and building frontage standards set forth in Table 537-5. TABLE 537-5 LOT COVERAGE; HEIGHT Table 537-5: Lot Coverage; Height Requirement Standard Limitations and Qualifications LOT COVERAGE Buildings and Accessory Structures All uses No Max. REAR YARD COVERAGE Buildings All uses No Max. Accessory Structures Accessory to all uses No Max. HEIGHT Buildings All uses Max. 50 ft. Accessory Structures Accessory to single family, two family, three family, four family, and multiple family Max. 15 ft. Accessory to all other uses Max. 50 ft. BUILDING FRONTAGE All uses Min. 50% Applies to development sites along Patterson Street, and along Edgewater Street and Second Street, between Rosemont Avenue and Wallace Road, except that where a development site has frontage on Edgewater Street, Second Street, or Patterson Street and a side street, the minimum building frontage requirement does not apply to the side street frontage. (f) Landscaping. Landscaping within the ESMU zone shall be provided as set forth in this subsection. (1) Setbacks. Required setbacks shall be landscaped. Landscaping shall conform to the standards set forth in SRC