22801 272nd St Maple Valley, WA 98038-6844

RLTC Dwelling, Single-Family P P P P 1 Factory-Built Home P 2 P 2 P 2 P 2 Duplex P 3 P 3 P 3 P 3 Triplexes and Fourplexes P 3 P 3 P 3 P 3 Townhouse P 3 P 3 P 3 P 3 A Stacked Flats P 3 P 3 P 3 Courtyard Apartments 17 P 3 P 3 P 3 Cottage Housing 17 P 3 P 3 P 3 Congregate Residence 18 C P P P 7 P 4, 12 P 4, 12 Group Home P 5 P 5 P 5 P 5 P 5 Bed and Breakfast C 6 C 6 C 6 C 6 Dwelling, Multiple-Family C P P P 7 P 3, 12 P 3, 12 Permanent Supportive Housing P 15 P 15 P 15 P 15 P 15 P 15 P 15 P 15 Transitional Housing P 15 P 15 P 15 P 15 P 15 P 15 P 15 P 15 Retirement Home P P Senior Assisted Housing P 5 P 5, 13 P 5, 13 P 5, 13 P 5 Nursing Home P 5 P 5 P 5 P 5 P 5 Home Occupation A 8 A 8 A 8 A 8 A 8 Accessory Dwelling Unit A 9 A 9 A 9 A 9 Dormitories A A Caretaker Dwelling Unit A 10 A 10 A 10 A 10 Animals A 11 A 11 A 11 A 11 A 11 A 11 A 11 B. Specific Requirements. 1. Existing single-family homes built before June 2025 in all lots zoned R-18/24 are considered permitted uses. 2. Mobile, manufactured and modular homes shall be subject to the following development standards: a. The home comprises at least one 14-foot-wide by 60-foot-long section or two parallel sections each of not less than 12 feet wide by 36 feet long; b. The home must be placed on a permanent foundation similar to that required of other residential construction; c. The home was originally constructed with and now has a pitched roof with a slope no less than three-inch rise to 12-inch run, and the roof must be an integral part of the home and shall be made of either composition, shakes or shingles (wood or metal); d. The home has exterior siding similar in appearance to siding materials commonly used on conventional site-built single-family residences; e. All requirements of this title and other applicable regulations must be met. 3. Unit Density. a. The permitted unit density on all lots zoned for residential use is: i. Two units per lot, unless zoning permitting higher densities or intensities applies. ii. Four units per lot if at least one unit on the lot is affordable housing meeting the requirements of subsections B.3.c through B.3.h of this section, unless zoning permitting higher densities or intensities applies. b. The standards of subsection B.3.a of this section do not apply to lots after subdivision below 1,000 square feet unless the City has enacted an allowable lot size below 1,000 square feet in the zone. c.